Alphacoolæs high-class solution for integration of single VPP and TPP pumps into a cooling loop.
Pump top and reservoir in one component offer many advantages: Easy mounting, compact dimensions and appealing looks! All this is combined and perfected in the new Alphacool Repack. But Alphacool would not be Alphacool if these new products would not feature innovations which were before not available in this configuration!
Alphacool Repack - Single Laing D5 - Dual 5,25 Bay Station is for designed installation in the front of an enclosure. For mounting two vacant 5.25ö drive bays are required.
Technological innovations featured in the Alphacool Repack:
So far the information about the reservoir sounds like a standard reservoir, but the developers have had many great ideas to solve common problems:
Different than standard solutions, where the coolant is guided around many edges and corners, still leaving micro-bubbles in the coolant, this reservoir uses a completely new technology. A new kind of filter is placed in front of both pump inlets, marked with ôinö & ôoutö, eliminating the problem of micro bubbles at the core.
On standard Slot-In reservoirs filling was a hassle: Unscrew, pull out, fill, fixate again. And during filling a third and fourth hand would always come in very handy, as it is always a very difficult operation to fill in the coolant. Enough! The front is equipped with a filling straw which can be released with few turns, and as it is hollow it can be used for filling of the reservoir. For this we recommend the filling bottles or straws from our portfolio.
Alphacool recommended for correct operation of the water cooling distilled water!
Material: Plexiglas/Acetal, Brass
Connection threads: 2x ?ô
Dimensions (L x W x H): 125 x 148 x 84mm
Mount for 10cm CCFL
Conforms with ROHSExtent of delivery:
1x Alphacool Repack - Single Laing D5 - Dual 5,25 Bay Station
8x Mounting screws
Note: The copper-colored logo is covered by a protective foil. To have the logo shining and clean, simply remove this foil.
Note regarding cathodes:
We have measured that the cathodes have manufacturing tolerances of up to 0.3mm, even amongst the cathodes in the same package. As the fit of the cathodes is meant to hold them in place, it might be that due to the tolerances the cathodes will not fit at first. The small amount of excess material can easily be removed with a few brushes of sandpaper.
Important Note: Please note that the firm Alphacool International GmbH accepts no liability for damages of this product by using other coolants. We would like to point out that other coolants as inhibitors often contain alcohol or other corrosive substances attack the acetal, please only use Cape Kelvin Catcher or Innovatek Protect.
|Connector:||G1/4" inner thread|
|Dimensions:||125 x 148 x 84mm|
|Fillport:||G1/4" inner thread|
|LED hole:||Available (for 5mm LEDs)|
|Material:||Plexi, POM, Brass|
|Model of reservoir:||2x 5 1/4" Bayres|
|Number of connections:||2|
|Pump compatibility:||For 1x D5|